If there are 6 coulombs of charge moving through a wire in 2 seconds. How many amps are moving through this wire?

F = ma

so, we can write it as;

= 5 = m × 20

= 5/20 = m

= 1/4 = m

= 0.25 kg = m

Light is a form of electromagnetic radiation with a wavelength which can be detected by the human eye. It is a small part of the electromagnetic spectrum and radiation given off by stars like the sun. Animals can also see light. The study of light, known as optics, is an important research area in modern physics.

Answer:

hope it is helpful to you

Answer:

61.62 N/m

Explanation:

Applying,

1/F = 2π[tex]\sqrt{m/k}[/tex].................. Equation 1

Where F = frequency, m = mass of the spring, k = spring constant, π = pie.

make k the subject of the equation

k = m(2πF)²............... Equation 2

From the question,

Given: m = 1.00 kg, F = 1.25 Hz

Constant: π = 3.14

Substitute these values into equation 2

k = 1(2×3.14×1.25)²

k = 61.62 N/m

Answer:

it reheated and use form another

Answer:

true is correct answer answer

Answer:

-1m/s

Explanation:

We can calculate the speed of block A after collision

According to collision theory:

MaVa+MbVb = MaVa+MbVb (after collision)

Substitute the given values

5(3)+10(0) = 5Va+10(2)

15+0 = 5Va + 20

5Va = 15-20

5Va = -5

Va = -5/5

Va = -1m/s

Hence the velocity of ball A after collision is -1m/s

Note that the velocity of block B is zero before collision since it is stationary

Answer:

Mechanical Advantage of car jack is 20

Explanation:

During the day the sky looks blue because it's the blue light that gets scattered the most. It's redirected into many different directions all over the sky, whereas the other wavelengths aren't scattered as much. Sunlight reaches Earth's atmosphere and is scattered in all directions by all the gases and particles in the air. Blue light is scattered more than the other colors because it travels as shorter, smaller waves. This is why we see a blue sky most of the time. White light is composed of seven light and among them, blue light scatters the most as the wavelength of the blue light is comparable to the size of particles in the atmosphere. So, the sky appears blue. Hence, the sky appears blue because the fine particles in the atmosphere scatter light of shorter wavelengths! :D

Answer:

V=IR

12 = 3 ×RESISTANCE

RESISTANCE=12/3

=4 Ohms

answer is the third option

Answer:

Explanation:

I'm assuming your charge is in Coulombs so I will proceed that way. The formula for this electric field problem is

[tex]E=\frac{kQ}{r^2}[/tex] where k = 9.0 × 10⁹. Filling in:

[tex]E=\frac{(9.0*10^9)(1.25*10^{-3})}{.4^2}[/tex] gives us an electric field value of

7.0 × 10⁷ N/C

Answer:

[tex]we \: know \: energy \: = \: force \: \times distance \\ e = f \times d \\ so \: f \: = \frac{e}{d} \\ so \: th \: force \: here \: = (\frac{2670}{3}) newton \\ = 890newton[/tex]

Hope it helps

Explanation:

hope it helps thanks

pls mark me as brainliest

Answer:

In the first one circle : luster

second circle: atsuete seeds

third: dentures

Explanation:

Well I ain’t sure

Answer:

Truss bridge, bridge with its load-bearing structures composed of a series of wooden or metal triangles, known as trusses. Given that a triangle cannot be distorted by stress, a truss gives a stable form capable of supporting considerable external loads over a large span.

Explanation:

Load-bearing capacity of truss bridges is huge due to the structure of interconnecting triangles. The structure effectively manages both compression and tension by spreading the load from the roadway throughout its intricate structure

Answer:

Acceleration. When an external force acts on an object, the change in the object's motion will be directly related to its mass. This change in motion, known as acceleration, depends upon the object's mass and the strength of the external force.

Answer:

a

Explanation:

because it has  compact  molecules  

[tex] \orange{\underline{\huge{\bold{\textit{\green{\bf{QUESTION}}}}}}}[/tex]

The apparent depth of an object at the bottom of a tank filled with a liquid of refractive index 1.3 is 7.7 cm. What is the actual depth of the liquid in the tank?

[tex]{\bold{\blue{GIVEN}}}[/tex]

REFRACTIVE INDEX = 1.3

APPARENT DEPTH = 7.7 cm

[tex]{ \bold{\green{To \: Find}}}[/tex]

REAL DEPTH OF THE OBJECT.

[tex]{\red{FORMULA \: \: USED }}[/tex]

[tex]Reflective \: Index = \frac{Real \: Depth}{Apparent \: Depth } [/tex]

[tex] \huge\mathbb{\red A \pink{N}\purple{S} \blue{W} \orange{ER}}[/tex]

Refractive Index = 1.3

Apparent Depth = 7.7 cm

Putting the values in the formula:-

[tex]Reflective \: Index = \frac{Real \: Depth}{Apparent \: Depth } \\ \\ 1.3 = \frac{Real \: Depth}{7.7 \: cm} \\ \\ 1.3 \times 7.7 = Real \: Depth \\ \\ 10.01 \: \: cm = Real \: Depth[/tex]

Answer:

 U = 25 J

Explanation:

The energy in a set of charges is given by

          U = [tex]k \sum \frac{q_i}{r_i}[/tex]

in this case we have three charges of equal magnitude

          q = q₁ = q₂ = q₃

with the configuration of an equilateral triangle all distances are worth

          d = a

          U = k ( [tex]\frac{q_1q_2}{ r_1_2 } + \frac{q_1q_3}{r_1_3} + \frac{q_2q_3}{r_2_3}[/tex] )

we substitute

           15 = k q² (3 / a)

            k q² /a = 5

For the second configuration a load is moved to the measured point of the other two

          d₁₃ = a

The distance to charge 2 that is at the midpoint of the other two is

          d₁₂ = d₂₃ = a / 2

           U = k (\frac{q_1q_2}{ r_1_2 } + \frac{q_1q_3}{r_1_3} + \frac{q_2q_3}{r_2_3})

            U = k q² (  [tex]\frac{2}{a} + \frac{1}{a} + \frac{2}{a}[/tex] )

            U = (kq² /a) 5

substituting

            U = 5 5

            U = 25 J

Answer:

Smart Meters measure both the amount of electrical energy used and the time at which it is being used because they are used to monitor the energy consumption at real time, such that the time of use of energy can be monitored, thereby enabling several utility functions for load sharing and maintenance, including;

i) Time of use  tariffs, where energy is billed based on peak and off peak periods, which increases profits to the producer, reduces cost for some consumers, encourages more even hourly and daily usage of electricity, lower maintenance cost, lower capital expenditure for peak stations, and reduces carbon emission

ii) Guarantees more accurate energy consumption measurement and billing

iii) Accurate crew dispatch to fault locations

iv) Prevent fraud due to tampering with meter

v) Increase customer confidence in billing

Explanation:

Answer:

8.5 Ω

Explanation:

La resistencia de un material es directamente proporcional a su longitud e inversamente proporcional al área de la sección transversal.

La fórmula de la resistencia (R) viene dada por:

R = ρL/A

Donde ρ es la resistividad del material, L es la longitud del material y A es el área de la sección transversal del material.

Dado que:

L = 1 km = 1000 m, A = 2 mm² = 2 * 10⁻⁶ m², ρ (cobre) = 1.7 * 10⁻⁸ Ωm

Sustituyendo da:

R = 1,7 * 10⁻⁸ * 1000/2 * 10⁻⁶

R = 8.5 Ω

Answer:

unbalanced force

Explanation:

well the seat brings you to a state of rest duw to the unbalanced force of the car stopping and the seat belt keeping you in place

It is true that the metal will begin to emit electrons at varied speeds depending on the intensity of the light when it is struck at a minimal wavelength.

When a waveform signal is propagated in space or over a wire, the wavelength is the separation between two identical locations (adjacent crests) in the adjacent cycles.

If you are employing light with a high enough frequency, the number of electrons ejected grows as the light source's brightness rises.

The velocity of the expelled electrons increases as the frequency is raised above the threshold.

Thus, the metal will begin to emit electrons at varied speeds depending on the intensity of the light when it is struck at a minimal wavelength.

To learn more about Wavelength, refer to the below link:

https://brainly.com/question/1263539

# SPJ2

Answer:

often Positive and negative charges balance each other which gives an overall neutral charge. if they are unbalanced then it will result in static electricity.

Answer/Explanation:

El Niño and la Niña, is a very rare/complex phenomenon that occurs in water. El Niño and La Niña are climate patterns in the Pacific that can affect weather everywhere basically worldwide.

~ LadyBrain

Answer:

221.29 Watts

Explanation:

P=W/t

P=686/3.1

P=221.29 Watts

10. True

11. True

12. True

13. False

14. False

Hope this helps!!

Answer:

halved.

Explanation:

Given the following data;

Potential difference = constant

Resistance = 2 * resistance = 2R

To find the current I;

Ohm's law states that at constant temperature, the current flowing in an electrical circuit is directly proportional to the voltage applied across the two points and inversely proportional to the resistance in the electrical circuit.

Mathematically, Ohm's law is given by the formula;

[tex] V = IR[/tex]

Where;

V represents voltage measured in voltage.

I represents current measured in amperes.

R represents resistance measured in ohms.

Making current (I) the subject of formula, we have;

[tex] I = \frac {V}{R} [/tex]

Substituting into the formula, we have;

[tex] I = \frac {V}{2R} [/tex]

[tex] I = \frac {1}{2} * \frac {V}{R} [/tex]

[tex] I = \frac {1}{2} * I [/tex]

Therefore, if the resistance of the resistor is doubled, the current through the resistor is halved.

Answer:

Explanation:

I got everything but i. Don't know why but it's eluding me. So let's do everything but that.

a. PE = mgh so

   PE = (2.5)(98)(14) and

   PE = 340 J

b. [tex]KE=\frac{1}{2}mv^2[/tex] so

   [tex]KE=\frac{1}{2}(2.5)(14)^2[/tex] and

   KE = 250 J

c. TE = KE + PE so

   TE = 340 + 250 and

   TE = 590 J

d. PE at 8.7 m:

   PE = (2.5)(9.8)(8.7) and

   PE = 210 J

e. The KE at the same height:

   TE = KE + PE and

   590 = KE + 210 so

   KE = 380 J

f. The velocity at that height:

   [tex]380=\frac{1}{2}(2.5)v^2[/tex] and

   [tex]v=\sqrt{\frac{2(380)}{2.5} }[/tex] so

   v = 17 m/s

g. The velocity at a height of 11.6 m (these get a bit more involed as we move forward!). First we need to find the PE at that height and then use it in the TE equation to solve for KE, then use the value for KE in the KE equation to solve for velocity:

   590 = KE + PE and

   PE = (2.5)(9.8)(11.6) so

   PE = 280 then

   590 = KE + 280 so

   KE = 310 then

   [tex]310=\frac{1}{2}(2.5)v^2[/tex] and

   [tex]v=\sqrt{\frac{2(310)}{2.5} }[/tex] so

   v = 16 m/s

h. This one is a one-dimensional problem not using the TE. This one uses parabolic motion equations. We know that the initial velocity of this object was 0 since it started from the launcher. That allows us to find the time at which the object was at a velocity of 26 m/s. Let's do that first:

   [tex]v=v_0+at[/tex] and

   26 = 0 + 9.8t and

   26 = 9.8t so the time at 26 m/s is

   t = 2.7 seconds. Now we use that in the equation for displacement:

   Δx = [tex]v_0t+\frac{1}{2}at^2[/tex] and filling in the time the object was at 26 m/s:

   Δx = 0t + [tex]\frac{1}{2}(-9.8)2.7)^2[/tex] so

   Δx = 36 m

i. ??? In order to find the velocity at which the object hits the ground we would need to know the initial height so we could find the time it takes to hit the ground, and then from there, sub all that in to find final velocity. In my estimations, we have 2 unknowns and I can't seem to see my way around that connundrum.